Specification

MAINTENANCE
CAUTION: NEVER PUT YOUR HAND INSIDE OF THE UNIT WHILE ITS OPERATING. FOR
THE BEST PERFORMANCE CLEAN YOUR
RANGE HOOD REGULARLY.
CLEANING
1.
Use only mild soap or cleaning solutions to clean the hoods'
outer surface. Dry surfaces using a soft cloth.
2. Stainless Steel cleaner may be used on the external surface.
3. Clean the Range Hood assembly 3 to 6 months depending on use.
4.
DO NOT clean the motor or electrical components with water or
any other liquid.
Replacing LED 2W 120V Light Fixture
1. Remove the aluminum filters
2. Make sure the range hood is unplugged or turn OFF breaker and the
lights are cool to touch.
3. Place a flat-head screwdriver between light housing and hood body.
4. Gently pry up the light housing and search for the metal clip.
5. Apply force to the metal clip and pull out the light fixture.
6. Disconnect the power cable and discard the old light fixture.
7. Reverse the steps to install a new LED light fixture.
8. Reinstall the aluminum filters.
9. Turn ON breaker and range hood to test for operation.
10. If you have questions about the replacing of LED Light, please contact
us at: [e-mail], and we will help you in time.
14
TROUBLESHOOTING
CAUTION: ALWAYS UNPLUG UNIT FROM POWER BEFORE SERVICING
PROBLEM SOLUTION TOOLS
My range hood is
noisy.
A. Check inside the range hood
for any loose debris and remove.
Phillips Screwdriver
My range hood has
poor performance.
A. The range hood and cook top
are too far
away from each other.
Optimal distance is 24” to 36”
B. There are too many open
windows or doors in the area.
Close some doors or windows.
C. The motor performance has
decreased due to wear. Replace
motor.
D. Check and make sure the tape
holding down the damper flaps at
the vent hole are removed before
use.
Phillips Screwdriver
My range hood
shakes.
A. The installation is not secure.
Check again and make sure the
installation hardware is securely
mounted.
B. The fan is broken or not
balanced. Realign or replace fan.
C. The motor is loose. Check and
make sure the motor is solidly
mounted to the unit.
Phillips Screwdriver
The motor no longer
runs.
A. Replace control panel or
circuit board.
B. Replace with new motor
assembly.
Phillips Screwdriver
Light bulb went out.
A. Replace with a new LED Bulb
2watt max.
Phillips Screwdriver
15