User Manual User guide

132

MODEL RL5000 USER MANUAL

Shut Down / Apply Power Using Power Supply ON/OFF Switch

1. Open the top of the ATM by unlocking the top enclosure and pulling the

hinged door forward.

2. Locate the ON/OFF switch on the POWER SUPPLY, as shown in Figure 7-9.

Move switch to the OFF <0> position.

3. To RESTART after shut down, move the ON/OFF switch to the ON <I> position.

4. The terminal software will re-initialize. The terminal will automatically attempt to

clear any error conditions during the start-up sequence. This may take several

minutes. When complete, the top menu appears.

After about a 30-second delay, one of two screens will appear:

• If the error condition was successfully cleared, the Customer Welcome

screen will appear. The terminal will resume normal operations.

• If the error condition was not successfully cleared (or another error condition

exists), the Terminal Error screen will appear.

WARNING

The control panel is provided with a pneumatic piston to prevent the door from

extending too far when opening and from being closed too quickly. In the un-

likely event of the pneumatic piston not functioning properly, the panel should

be prevented from opening too far and from being slammed when closing.

Fig. 7-9. Power supply ON/OFF

switch location.