LP Gas Guide

English 3

4. To facilitate the removal of the spill trays, depending on

model, remove the (3) or (4) T-20 Torx stainless screws

in the front face of the included Flush Island Trim.

5. Disconnect the igniter.

A.) Disconnecting a Two Piece Igniter

1) Carefully pull up on the burner base.

B.) Disconnecting a Single Piece Igniter

1) Carefully pull up on the burner base.

2) Disconnect the female terminal on the spark wire

from the male terminal on the electrode for each

burner.

IMPORTANT: The locking tab on the female

connector must be depressed to release from the

terminal on the electrode.

6. From each burner pedestal, remove the burner

pedestal screws with a T-30 Torx screwdriver.

7. Carefully remove the burner pedestal and the venturi.

8. Remove the spill trays by rotating the trays up and out

the back.

9. Remove the heat shield, on some models. Some

models have a double-width shield that extends under

adjacent spill tray.

Regulator Conversion

The gas regulator is located in the cooktop, left side of

appliance. Exact location will vary per model.

Ignitor Housing

Electrode

Ignitor Wire

Burner Base

Electrode

Ignitor Wire

Burner Base

Burner Pedestal

Venturi