Datasheet

www.ti.com
TYPICAL CHARACTERISTICS
TYPICAL AC PERFORMANCE: V
S+
– V
S–
= 5 V
THS4520
SLOS503B – SEPTEMBER 2006 – REVISED JULY 2007
Test conditions unless otherwise noted: V
S+
= +2.5 V, V
S–
= –2.5 V, CM = open, V
O
= 2 V
PP
, R
F
= 499 Ω , R
L
= 200 Ω
Differential, G = 0 dB, Single-Ended Input, Input and Output Referenced to Midrail
Small-Signal Frequency Response Figure 1
Large Signal Frequency Response Figure 2
HD2 vs Frequency, V
O
= 2 V
PP
Figure 3
HD3 vs Frequency, V
O
= 2 V
PP
Figure 4
HD2 vs Frequency, V
O
= 4 V
PP
Figure 5
HD3 vs Frequency, V
O
= 4 V
PP
Figure 6
HD2 vs Output Voltage Swing, f = 1 MHz Figure 7
HD3 vs Output Voltage Swing, f = 1 MHz Figure 8
HD2 vs Output Voltage Swing, f = 8 MHz Figure 9
Harmonic Distortion
(1)
HD3 vs Output Voltage Swing, f = 8 MHz Figure 10
HD2 vs Load Resistance, f = 1 MHz Figure 11
HD3 vs Load Resistance, f = 1 MHz Figure 12
HD2 vs Load Resistance, f = 8 MHz Figure 13
HD3 vs Load Resistance, f = 8 MHz Figure 14
HD2 vs Output common-mode voltage Figure 15
HD3 vs Output common-mode voltage Figure 16
0.1 dB Flatness Figure 17
S-Parameters vs Frequency Figure 18
Slew Rate vs Output Voltage Figure 19
Gain = 6 dB, V
O
= 4 V
PP
Figure 20
Transient Response
Gain = 6 dB, V
O
= 2 V
PP
Figure 21
Output Voltage Swing vs Load Resistance Figure 22
Input Offset Voltage vs Input Common-Mode Voltage Figure 23
Input Bias Current vs Supply Voltage Figure 24
Open Loop Gain and Phase vs Frequency Figure 25
Input Referred Noise vs Frequency Figure 26
Quiescent Current vs Supply Voltage Figure 27
Power Supply Current vs Supply Voltage in Powerdown Mode Figure 28
Output Balance Error vs Frequency Figure 29
CM Small-Signal Frequency Response Figure 30
CM Input Bias Current vs CM Input Voltage Figure 31
Differential Output Offset Voltage vs CM Input Voltage Figure 32
Output Common-Mode Offset vs CM Input Voltage Figure 33
(1) For additional plots, see the Applications section.
8
Submit Documentation Feedback