Installation Guide

INSTALLATION
WideSky.Cloud Pty Ltd
rev-12
Page7of10
1.
2.
3.
4.
•
•
•
•
3 Installation
The installation must only be performed by qualified and authorized personnel.
Steps:
The device is in a standard DIN-rail enclosure, it needs to be ‘clicked’ onto the rail. Make
sure the rail latch at the bottom of the device is securely latched to the rail.
Terminate the cables and insert the screw terminals.
Fasten screws with a maximum torque of 0.5Nm.
Screw the antenna on the provided connector.
2 Attach to DIN

3 Terminate cables and
insert terminals
4 Attach antenna

3.1 Warnings and Declaration
3.2 General
Installation and service must be performed by qualified and authorized persons only.
Make sure power is OFF during installation
DO NOT use this device in an environment with direct exposure to water
DO NOT use the device in a direct outdoor environment without an electrical enclosure
Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment

3.3 Federal Communications Commission:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.