CH - Hub: User/Installation Guide REV: 12 - 02/09/2022
WideSky Hub – 1CH - Hub: User/Installation Guide Table of Contents 1 Overview................................................................................................. 3 2 Specifications ......................................................................................... 4 2.1 Electrical ..................................................................................................................4 2.2 Radio.....................................................................................
OVERVIEW 1 Overview 1 WideSky Hub - Model: 1P-AC The WideSky Hub-1S is a wireless IoT data collection and control device which operates on the 2.4GHz ISM band using IEEE 802.15.4 communications. There are no user-serviceable parts and no configuration access for the user. The maximum transmission power is fixed by user inaccessible software configurations to the region’s regulatory limits. WideSky.
SPECIFICATIONS 2 Specifications 2.1 Electrical Input Voltage 100ACV - 240ACV Frequency 50/60 Hz Max. Current 0.15A Max. Operation Temperature 70°C 2.2 Radio Standard IEEE 802.15.4 (Zigbee / Thread) Operation Frequency 2400 - 2483.5 MHz ISM band No of Channels 16 Max Transfer Rate 250kbps Modulation O-QPSK Max. Transmit Power Automatic limitation to regional regulatory limitations (e.g. for US (FCC) 20dbm, Europe (CE) 10dbm) 2.3 Antenna Pulse Larsen Antenna, manuf. Part no.
SPECIFICATIONS Impedance: 50 Ohm VSWR <= 2.0 Polarization Vertical Electrical Length: ¼, dipole Radiation: Omni directional 2.4 Mechanics Enclosure ABS with mounting hardware Mounting DIN-rail Dimensions 35x57x86mm (WxHxD) Weight 0.3kg Operating Temp -20 to +70 °C Humidity 5-95% RH IP Rating 30 2.5 Environment Operating Temp -20 to +75 °C Humidity 5-95% RH WideSky.
SPECIFICATIONS 2.6 Connections There are three connectors on the hub: 1. A three-pin AC input terminal block 2. A five-pin DC terminal block for communications 3. An SMA antenna jack. The AC input requires the usual L/N/PE lines, the DC connector has two RS485 differential lines (A/Y & B/Z), a Ground terminal and a digital pulse input. The fifth line is unused and not connected.
INSTALLATION 3 Installation The installation must only be performed by qualified and authorized personnel. Steps: 1. The device is in a standard DIN-rail enclosure, it needs to be ‘clicked’ onto the rail. Make sure the rail latch at the bottom of the device is securely latched to the rail. 2. Terminate the cables and insert the screw terminals. 3. Fasten screws with a maximum torque of 0.5Nm. 4. Screw the antenna on the provided connector.
INSTALLATION Caution: The user is cautioned that changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
INSTALLATION Déclaration d’exposition aux radiations: Cet équipement est conforme aux limites d’exposition aux rayonnements IC établies pour un environnement non contrôlé. Cet équipement doit être installé et utilisé avec un minimum de 20 cm de distance entre la source de rayonnement et votre corps. WideSky.
CERTIFICATIONS [WIP] 4 Certifications [WIP] To be completed once the relevant certifications have been obtained WideSky.
