Connect Setup uk 06 2017 V3

12
|
Systemair Connect set-up
Prepare your Device for Systemair Connect by
using E tool
Note: This section applies only to E tool version 3.2
and later versions. If you are using an earlier version of
E tool please update to the latest version
.
Download and install the latest version of E tool from
www.regincontrols.com or from www.systemair.dk under
Support and E tool.
1. Open E tool, select Tools and Communication
settings... to find the Device on the network.
Note: You must be connected to the same network as
the controllers you want to configure.
2. Select ”Use a TCP/IP port in this controller” and click OK.