User Manual

Instruction Manual

NOTE:

a. When the copy is in progress, the green LED will ash for each Flash drive that is

connected. When the copy has nished, the green LED will stop ashing and remain

illuminated. If an error occurs, the red LED will illuminate.

b. Do NOT remove the Flash drive while the system is copying (green LED is ashing).

c. Once the copy process has completed (green LED is solid), you can then take out

that Flash drive and insert a new one.

d. During an Asynchronous copy, you can press the up and down arrows to check

each Flash drive’s copy status and progress. This works both during a copy (green

LED ashing) and when there is an error (red LED solid).

2. Compare

Check the Flash drive after a copy has completed to ensure the copy has

completed successfully.

3. Copy + Compare

Automatically compares the Flash drive once the copy has completed.

4. Capacity Check

Check the exact capacity of the connected Flash drive in the destination slots.

1. Plug the Flash drive into the slot and press OK on Capacity Check. The system will

quickly report the exact capacity of the connected Flash drive by reporting either a

green or red LED. Use the up and down arrows to move between slots.

2. This function supports Asynchronous operation. You can continuously remove and

connect multiple Flash drive types without pushing any buttons.