Manual

Instruction Manual
3
Hardware Installation
1. Use static electricity discharge precautions
Eliminate the potential for static discharge from any objects that the hub may come
in contact with before the installation. This can be accomplished by touching a bare
metal chassis rail after you have turned o the power.
2. Apply DC power to the 3-pin Terminal Block Connector
The terminal block connector adds power to ensure there is enough to run the 4
downstream USB ports.
3. Connect the USB host cable
The host cable is a standard A-to-B USB2.0 cable. Connect the type-A connector to
the upstream USB port being used, then connect the type-B connector to the USB
hub. Since the hub is plug and play, it can be connected while the host computer is
powered on.
4. Connect the USB devices to the downstream ports of the hub.
5. Mount the hub on the wall or DIN RAIL if required.