Owner manual

SHEL LAB SI6/SI6R Shaking Incubator Operational Manual

sterilizing your unit, see “Disinfecting Your Unit“

on page 14.

Installing Sample Tray

Your unit comes with a sample tray as standard

equipment.

To install the sample tray

1. Enclose all corners of the shaking mechanism

within the lips of the sample tray. This can be done

easily by positioning the front two corners and

then setting the rest of the tray down.

2. Shake the tray by its handles to confirm that it is

firmly in place.

Plugging the Unit into a

Power Source

We recommend that you plug your incubator into a

circuit separate from other equipment. This prevents

damage or destruction of the incubator caused by

overloading or failure of other equipment on the same

circuit.

The electrical supply circuit to the incubator must

conform to all national and local electrical codes. The

voltage supplied to your unit should not vary more than

10%.

WARNING

For your own safety, do not plug the unit into a power

source until you have read and understood the safety and

operational instructions in this manual.

To connect the unit to a power source

1. Be sure the plug and the cord are in good

condition. If the power cord is worn, cut or

damaged in any way, do not use it. Contact

customer service for a replacement power cord.

For information on contacting customer service,

see page 20.

2. Plug the service cord firmly into a grounded

electrical outlet. If the plug does not fit the outlet,

have a proper outlet installed by a qualified

electrician.