User Manual

10. At this time, there is still a certain gap between the attached panel of the mainframe and the roof, so the attached
panel of the mainframe should be pulled out and pushed to contact with the roof, and then the attached panel of the
mainframe should be fixed on the roof with ST4.2×18 screws.
11
bottom of the mesh enclosure and power it for trial operation.
. After installation, the whole machine must be kept horizontal. In the end, insert the oil cup into the hitching leg on the
32
1. Open the container and take out the machine, and check the items inside against the packing list.
●Installation with an upper cabinet
2
leg, and mark it with a pencil.
. Draw a vertical center line in the installation position, and then use the beam detector to find the beam to fix the hitching
Note: The hitching leg must be fixed on the beam with a screw.
With the stove bearing surface as the base, mark the drill holes in the corresponding position of the wall according to
the distance from the hitching leg hole to the bottom of the machine, and the height of the bottom of the hanging
cabinet.The relevant size is given as below:
1). Range hood: the distance from the bottom of the machine (the bottom of the cabinet) to the stove bearing surface is
9 9
25- /16 -29- /16”(650-750mm);
1
2). Hitching leg: the distance from the center hole of the hitching leg to the bottom of the machine is 20- /2”(520mm);
3). Hitching leg stop block: the distance from the hitching leg stop block fixing hole to the center hole of the hitching leg
7
is 2- /16”(62mm).
3. Determine the positions to fix the hitching leg and the hitching leg stop block.
Range Hood