System information

Managed Gigabit Switch
20 T1000-TM-EN-2
20
100Mbps FDX - Forces the cu port in 100Mbps full duplex mode.
1Gbps FDX - Forces the port in 1Gbps full duplex
2.Gbps FDX - Forces the Serdes port in 2.Gbps full duplex mode.
SFP_Auto_AMS - Automatically determines the speed of the SFP. Note: There is no standardized way to
do SFP auto detect, so here it is done by reading the SFP rom. Due to the missing standardized way of
doing SFP auto detect some SFPs might not be detectable. The port is set in AMS mode. Cu port is set in
Auto mode.
100-FX - SFP port in 100-FX speed. Cu port disabled.
100-FX_AMS - Port in AMS mode. SFP port in 100-FX speed. Cu port in Auto mode.
1000-X - SFP port in 1000-X speed. Cu port disabled.
1000-X_AMS - Port in AMS mode. SFP port in 1000-X speed. Cu port in Auto mode.
Ports in AMS mode with 1000-X speed has Cu port preferred.
Ports in AMS mode with 1000-X speed has fiber port preferred.
Ports in AMS mode with 100-FX speed has fiber port preferred.
Flow Control
When Auto Speed is selected on a port, this section indicates the flow control capability that is
advertised to the link partner.
When a fixed-speed setting is selected, that is what is used. The Current Rx column indicates whether
pause frames on the port are obeyed, and the Current Tx column indicates whether pause frames on
the port are transmitted. The Rx and Tx settings are determined by the result of the last Auto-
Negotiation.
Check the configured column to use flow control. This setting is related to the setting for Configured
Link Speed.
Maximum Frame Size
Enter the maximum frame size allowed for the switch port, including FCS.
Excessive Collision Mode
Configure port transmit collision behavior.
Discard: Discard frame after 16 collisions (default).
Restart: Restart backoff algorithm after 16 collisions.
Buttons
SAVE: Click to save changes.
RESET: Click to undo any changes made locally and revert to previously saved values.
REFRESH: Click to refresh the page. Any changes made locally will be undone.