System information

155
QoS Ingress Queue Policing
Configuration
This page allows you to configure the Queue Policer settings for all switch ports.
The displayed settings are:
Port
The port number for which the configuration below applies.
Enabled (E)
Controls whether the queue policer is enabled on this switch port.
Rate
Controls the rate for the queue policer. The default value is00. This value is restricted to 100-1000000
when the "Unit" is "kbps", and it is restricted to 1-13200 when the "Unit" is "Mbps".
This field is only shown if at least one of the queue policers are enabled.
Unit
Controls the unit of measure for the queue policer rate as kbps or Mbps. The default value is "kbps".
This field is only shown if at least one of the queue policers are enabled.
Buttons
SAVE: Click to save changes.
RESET: Click to undo any changes made locally and revert to previously saved values.