User Manual

12
3.5 Physical Installation
1. Connect an Ethernet cable
 ConnecttheLANcableonthePTInternetCameratothenetworkdevice(hubor
switch).
Note
If there has an IEEE802.3af PoE switch in your network, you can
connect the ICA-230/M230 LAN cable to this PoE switch to obtain
power. The power adapter is unnecessary when ICA-230/M230 is
connected to a PoE switch.
2. Check the LED (Front Panel)
 TheLEDisdenedtoidentifyLANconnectiontype.WhenLANportisconnected,
theLEDwillbegreen.
3.PlacethePTInternetCameraonthetableorxitontoceilingorwall
 UsescrewstoxthePTInternetCameraontotheceilingorwall.Youcouldalso
putthePTInternetCamerainthetabledirectly.
4.Attachthepowersupply
Plug in power adapter and connect to power source. After power on, PT Internet
Camera will start to operate.
Note
Only use the power adapter supplied with PT Internet Camera.
Otherwise,theproductmaybedamaged
The power adapter is unnecessary when ICA-230/M230 is connected
to a PoE switch. Otherwise, the product may be damaged when
ICA-230/M230 is connected to a PoE switch and power adapter
simultaneously.
5.AttachSpeakertoPTInternetCamera(option)
 If user needs not only video stream but also audio stream, then the speaker
shouldbeattachedtoPTInternetCamera.