Owner manual

ULTRA EDGE SEQUENTIAL 6/05/2002
15
If any value is assigned for this parameter, the feed will move material back for the distance that equals Back Length
when:
-In the Press application, the cutter bottom position sensor turns on between the end of the Feed Cam signal and the
beginning of the Reset Cam signal, while only one Gag output is active (fired) in the current step.
-In the Punch application, the cutter bottom position sensor turns on within Dwell time and the Feed signal remains
on.
The Back Length is compensated on the next move, so it has no affect on the Length parameter. It is a numeric entry,
with a range of 0 to 1 inch.
Kerf is a cutting tool width and used for Cut-to-Length application to compensate for a loss of the Length caused by
width of the tool. It is a numeric entry, with a range of 0 to 10 inches.
Max length is a Length limit and protects against accidental entering extra digits, for example: 100 inch instead of 10
inch. It is a numeric entry, with a range of 0 to 999999. (This value is factory set to 20.000.)
NOTE: To exit setup editing at any time, press the “OPER” key. Changes will be saved.
4 HOW TO …
4.1 HOW TO CREATE A NEW TOOL
NOTE: Make sure that the PROGRAMMING “LOCKED / UNLOCKED” key switch is in “Unlocked”
position and FEED STATUS screen is displayed. If the current screen is not FEED STATUS one then press
the “OPER” key to bring it up.
Press the “TOOLS” key.
Position the pointer next to Create new tool command and press the “ENTER” key.
E d i t T o o l
A c t i v a t e T o o l
C r e a t e N e w <
P r e s s T O O L S t o E x i t
Enter a new tool number and press the “ENTER” key again.
C r e a t e T o o l #
P r e s s T O O L S t o E x i t
C r e a t e # 1
T o o l C r e a t e d