Owner manual

ULTRA EDGE SEQUENTIAL 6/05/2002
12
The Insert command allows a step to be placed before or after the current step.
T # 1 S # 2 0 / 2 4
L e n g t h 6 0 . 0 0 0
G a g s 0 0 0 1 1
P r e s s T O O L S f o r n e x t
Press F1, then position the cursor next to Insert Step command and press Enter key:
A d d S t e p
D e l e t e S t e p
I n s e r t S t e p <
P r e s s F 1 f o r n e x t
Position the cursor next to desired command and press Enter key:
I n s e r t S t e p
B e f o r e S t e p 2 0 <
A f t e r S t e p 2 0
P r e s s B K S P f o r p r e v .
The Copy command can be executed from any step:
T # 1 S # 2 0 / 2 4
L e n g t h 6 0 . 0 0 0
G a g s 0 0 0 1 1
P r e s s T O O L S f o r n e x t
Press F1,
A d d S t e p <
D e l e t e S t e p
I n s e r t S t e p
P r e s s F 1 f o r n e x t
Press F1 again,
C o p y S t e p <
F 1 - E x i t B K S P - P r e v
Specify which step is to be copied and where to, then position the cursor next to command Perform Copy and press
Enter key.
C o p y S t e p 3
I n t o S t e p 7
P e r f o r m c o p y <
P r e s s B K S P f o r p r e v .
S t e p c o p i e d !