User Manual

Section 5 Recorder Setup
I. Page 57 1/06/2012 REV 1.10.2
Exit: Pressing this button will exit without saving any changes made in THIS dialog box ONLY. If
you used the Setup or Alarms buttons to make changes to the channel information, these are Global and
WILL be saved.
Setup: Pressing this button opens the Channel Setup window. This allows changes to be
made to the channel settings which will affect ALL widgets using this channel. This is a
protected option.
Delete: Pressing this button will DELETE the Digital Display Widget. This will remove it from
the display.
5.3.1.2 Displaying Min, Max or Average Values
The Digital Display widgets show the instantaneous channel value but can be
changed at any time to display minimum, maximum or average values. To
change the reading double tap in the lower line of the digital display widget
indicated right.
This will pop up a drop down menu that allows the user to select the display
mode as follows.
INST. = Instantaneous display the data as it is read default (real time
display)
MIN. Minimum - will display the minimum (lowest) value ever measured.
MAX. Maximum will display the maximum (highest) value ever measured
AVG. Average will perform a weighted average on all input samples at 10
samples/sec and average them as (last value + current value)/2 and
display this. Note you can use the Filter on each channel to provide
additional averaging.
The display indicated the current display mode in the lower left of the display
widget using the characters above - with the exception that NO indicator
is shown for real time (instantaneous) value. Maximum value is shown displayed
right.