User Manual

Section 6 - Communication
I. Page 102 1/06/2012 REV 1.10.2
6.6.2.2 Remote Manager
The Remote Manager program is installed from the software installation disk that came with the
recorder. This program will run on a WAN (Wide Area Network) – over the Ethernet and will work
through a Firewall if the firewall is set up correctly. It will work over a LAN (Local Area Network)
but the Remote Display is more responsive as it uses multiple ports. Once installed The Remote
Manager is launched by double clicking the Remote Manager Icon shown right. This launches the
program window as shown below.
Select an IP Address from the pull down menu or add a new one by clicking the ADD
Recorder Icon – shown right. This will pop up a form shown left to enter IP Address,
Description and User name. Once this is added click the ADD button to close.
Enter the password (which is never stored) and then press the Connect Icon
(right). If the user name and password is correct and the recorder is
accessible an image of the recorder screen will appear in the window as
shown below. If the program has to navigate the WAN it make take several seconds to connect.
Fig 6.5.5 - Remote Manager Connected
You may control the recorder any way you wish. To terminate the connection hit the “X” in
the upper right corner or preferably the disconnect button in the control window(right).
You can zoom the display by pressing the Zoom Icon.
Fig 6.5.4 - Remote Manager