Datasheet

PIC18F47J53 FAMILY
DS39964B-page 118 Preliminary  2010 Microchip Technology Inc.
7.5.3 WRITE VERIFY
Depending on the application, good programming
practice may dictate that the value written to the
memory should be verified against the original value.
This should be used in applications where excessive
writes can stress bits near the specification limit.
7.5.4 UNEXPECTED TERMINATION OF
WRITE OPERATION
If a write is terminated by an unplanned event, such as
loss of power or an unexpected Reset, the memory
location just programmed should be verified and
reprogrammed if needed. If the write operation is
interrupted by a MCLR
Reset, or a WDT time-out Reset
during normal operation, the user can check the
WRERR bit and rewrite the location(s) as needed.
7.6 Flash Program Operation During
Code Protection
See Section 28.6 “Program Verification and Code
Protection” for details on code protection of Flash
program memory.
TABLE 7-2: REGISTERS ASSOCIATED WITH PROGRAM FLASH MEMORY
Name Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0
TBLPTRU — — bit 21 Program Memory Table Pointer Upper Byte (TBLPTR<20:16>)
TBPLTRH Program Memory Table Pointer High Byte (TBLPTR<15:8>)
TBLPTRL Program Memory Table Pointer Low Byte (TBLPTR<7:0>)
TABLAT Program Memory Table Latch
INTCON GIE/GIEH PEIE/GIEL TMR0IE INT0IE RBIE TMR0IF INT0IF RBIF
EECON2 Program Memory Control Register 2 (not a physical register)
EECON1
— — WPROG FREE WRERR WREN WR —
Legend: — = unimplemented, read as ‘0’. Shaded cells are not used during Flash program memory access.