Installation Guide

Page 9
Operation
Slide controls:
Moving a slide control will cause an immediate takecontrol of all dimmers assigned to that
zone. The lighting levels will fade up or down quickly to match the slide control level, and the
LED of the zone will illuminate indicating that the slider has full control (This feature may be
modified through computer software wheras the MANUAL button must first be pressed to gain
control).
The LED of the zone will go out when either the PRESET or ALL OFF button is pressed, or if
another panel gains control of the dimmer channel assigned (A control console will not affect
the LEDs).
Default dimmer assignment are : Zone 1-4 (1-8) = Dimmer Channel 1-4 (1-8).
MANUAL button:
When pressed, this button will cause all dimmer channels assigned to all zones of this panel
to fade to the current settings of the slide controls. All zone LEDs will come on and the slide
controls will have full control.
PRESET button:
This button will cause all dimmer channels assigned to all zones of this panel to fade to the
zone setting previously programmed (Default is all full on). All zone LEDs will go out.
ALL OFF button:
This button will cause all dimmer channels assigned to all zones of this panel to fade to the
zone setting previously programmed (Default is all full off). All zone LEDs will go out.
To restore control from a console:
Simply perform a change in the channel level from the console. The lighting channel will
then fade back to the new console level at the factory default fade rate. Once the console
level matches or is moved past the lighting level, full console control will be resumed for that
channel.
LUMA-NET
LUMA-NET
MEMORY LIGHTING CONTROLLER
PRESET
MANUAL
OFF
PRESET
MANUAL
OFF
MEMORY LIGHTING CONTROLLER
CONTROL ACTIVECONTROL ACTIVE
804 CP
808 CP
PWR BUSY PWR BUSY
WEB VERSION