Installation & Operation Guide 804CP / 808CP WEB VERSION Remote Control Panel
Page 2 WEB VERSION
Table of Contents INTRODUCTION ................................................................................................................. 4 IMPORTANT......................................................................................................................... 4 WIRING................................................................................................................................. 4 PROGRAMMING...................................................................................
Introduction The Leviton 804CP and 808CP represents a key part of a state of the art, total lighting control system. Combined with Leviton dimmers and optionally, a Leviton memory control console, a totally integrated system is achieved. The 804CP and 808CP can automatically take control and preset the lighting level of up to 100 dimmer channels. Control is automatically passed between control panels and the memory control console as desired.
MOUNTING The 804CP and will mount in any standard double-gang electrical box, while the 808CP will mount in a large three-gang box with the 4 screws provided. See below paragraph on system turn-on before final mounting of panels. SYSTEM TURN-ON It is very important that the system operation be verified one panel at a time or else an improper connection at one panel would cause the entire system to not operate properly and may be difficult to diagnose.
Programming The 804CP and the 808CP come from the factory programmed for the following, unless special factory programming was requested: Dimmer channels for each zone: Zone 1-4 (1-8) = Ch 1-4 (1-8) respectively Fade time for each zone and presets: 1 second PRESET button levels: Zone 1-4 (1-8) full ALL OFF button levels: Zone 1-4 (1-8) off The installer may reprogram the PRESET and ALL OFF buttons easily without additional equipment.
Programming the PRESET and ALL OFF buttons: In order to program panels, a jumper block must be removed from the program jumper pins. This will allow data to be stored in the eeprom memory. At this point the BUSY LED will start flashing, indicating that you are in the program select mode. IMPORTANT: After programming it is important to replace the programming jumper block so memory will be protected. DO NOT press all three buttons down simultanously while the jumber is removed, this will erase programming.
ID number 0 3 6 9 12 15 18 21 24 27 30 33 36 39 42 45 48 51 54 57 60 63 66 69 72 75 78 81 84 87 90 93 96 99 102 105 108 111 114 117 120 123 126 12345678 00000000 11000000 01100000 10010000 00110000 11110000 01001000 10101000 00011000 11011000 01111000 10000100 00100100 11100100 01010100 10110100 00001100 11001100 01101100 10011100 00111100 11111100 01000010 10100010 00010010 11010010 01110010 10001010 00101010 11101010 01011010 10111010 00000110 11000110 01100110 10010110 00110110 11110110 01001110 1010111
Operation Slide controls: Moving a slide control will cause an immediate takecontrol of all dimmers assigned to that zone. The lighting levels will fade up or down quickly to match the slide control level, and the LED of the zone will illuminate indicating that the slider has full control (This feature may be modified through computer software wheras the MANUAL button must first be pressed to gain control).
WEB VERSION NOTES Page 10
WEB VERSION NOTES Page 11
LIMITED 2 YEAR WARRANTY AND EXCLUSIONS Leviton warrants to the original consumer purchaser and not for the benefit of anyone else that this product at the time of its sale by Leviton is free of defects in materials and workmanship under normal and proper use for two years from the purchase date. Leviton’s only obligation is to correct such defects by repair or replacement, at its option. For details visit www.leviton.com or call 1-800-824-3005.
