Installation Guide

ManualsBrandsKOHLER ManualsKitchenOnCue Plus Generator Management System

4 TT-1628 3/14

1. Click on the genset to be updated

2. Update Firmware button

3. Change Password button

4. Parameters View

5. Genset Serial Number

2 4

SGM1234567

Figure 5 OnCue Parameters View

9. Update the RDC/DC controller firmware using

OnCuer, your Windowsr PC and a USB cable:

Note: For the RDC2/DC2 controller, go to step 10.

a. In the panel on the left side of the screen, click

on the generator set to be updated. See item 1

in Figure 5. You must select the generator

connected directly to the laptop with a USB

cable.

b. Click on the Update Firmware button. See

Figure 5.

c. Click Browse for firmware file. Navigate to the

location where the firmware file Rdc_3.18.0.bin

wasstoredinstep3.

d. Double click on the .bin file and then click

update firmware. A message will appear on the

computer screen when the firmware is

successfully updated.

e. Put your controller back in Auto b y pressing the

Auto button on your RDC controller.

10. Update the RDC2/DC2 controller firmware using

OnCue, your Windows PC and a USB cable:

a. In the panel on the left side of the screen, click

on the generator set to be updated. See item 1

in Figure 5. You must select the generator

connected directly to the laptop with a USB

cable.

b. Click on the Update Firmware button.

c. Click Browse for firmware file. Navigate to the

location where the firmware file Rdc2_5.7.0.bin

wasstoredinstep3.

d. Double click on the .bin file and then click

update firmware. A message will appear on the

computer screen when the firmware is

successfully updated.

e. After the RDC2 firmware is updated, the

controller display will prompt you to set the

date, time, and exerciser.

f. The setting will flash on the controller display.

Press the up or down arrow button to change

the setting. Press the select button to save the

setting. The next setting will flash.

g. After setting the date, time, and exerciser, put

the controller back in Auto by pressing the Auto

button on your RDC2 controller.

11. Close OnCue and disconnect the laptop from the

controller.