System Startup, Configuration, and Shutdown Reference Manual (32650-90892)

42 Chapter2
Initiating System Activity
The Booting Process
Main Menu: Enter command or menu > bo
Interact with IPL (Y, N, or Cancel)?> y
Booting...
Boot IO Dependent Code (IODC) revision 1
SOFT Booted.
In this example, the system halts at ISL and then waits for the operator to issue an ISL
command. For more information on ISL and ISL utilities, refer to Chapter 3 , “System
Startup Functions.”
Bypassing the Disabled Autoboot Setting
Answering NO to the prompt Interact with IPL (Y or N)? causes the system to ignore
a disabled autoboot flag setting and attempt to autoboot.
Example 2-10 demonstrates bypassing a current disabled autoboot flag setting in order to
autoboot.
Example 2-8. Bypassing the Disabled Autoboot Setting When Booting a System
GSP> tc
TC
Execution of this command irrecoverably halts all system processing and
I/O activity and restarts the computer system.
Type Y to confirm your intention to restart the system: (Y/[N]) y
y
-> SPU hardware was successfully reset.
GSP Host Name: csyprel18(csysas18)
GSP>
********** VIRTUAL FRONT PANEL **********
System Boot detected
*****************************************
LEDs: RUN ATTENTION FAULT REMOTE POWER
FLASH FLASH OFF ON ON
platform config 626F