System Startup, Configuration, and Shutdown Reference Manual (32650-90892)

40 Chapter2
Initiating System Activity
The Booting Process
NOTE If you have a 99X system, you must transfer to the service processor before
you reset the system.
CM> SP
Example 2-7. Interactively Booting an N-Class System
GSP> tc
TC
Execution of this command irrecoverably halts all system processing and
I/O activity and restarts the computer system.
Type Y to confirm your intention to restart the system: (Y/[N]) y
y
-> SPU hardware was successfully reset.
GSP Host Name: csyprel18(csysas18)
GSP>
********** VIRTUAL FRONT PANEL **********
System Boot detected
*****************************************
LEDs: RUN ATTENTION FAULT REMOTE POWER
FLASH FLASH OFF ON ON
platform config 626F
processor test 1142
processor test 1100
. . .
platform test 612A
I/O config 8238
*****************************************
************ EARLY BOOT VFP *************
End of early boot detected
*****************************************
Firmware Version 21.32