MPE/iX Intrinsics Reference Manual (32650-90905)

Chapter 8 453
Command Definitions (HPMERGEEND-LOGSTATUS)
HPUNLOADCMPROCEDURE
HPUNLOADCMPROCEDURE
NM callable only.
Unloads a target CM procedure whose plabel is obtained through the HPLOADCMPROCEDURE
intrinsic.
Syntax
CA U8V I32
HPUNLOADCMPROCEDURE(
procname,library , status );
Parameters
procname character array (required)
Passes as ASCII procedure name, left-justified and padded with blanks.
The name can have a maximum of 16 characters.
library 8-bit unsigned integer by value (required)
Passes indicator of the CM segmented library to be searched. The valid
values are as follows:
Value Meaning
0 Search the system SL only (default)
1 Search the logon account SL, then the system SL
2 Search the logon group SL, then the logon account SL, and
then the system SL
3 Search the program file's account SL, then the system SL
4 Search the program file's group SL, then the program file's
account SL, and then the system SL
status 32-bit signed integer by reference (optional)
Returns the status of the HPUNLOADCMPROCEDURE intrinsic call. If no errors
or warnings are encountered,
status returns 32 bits of zero. If errors or
warnings are encountered,
status is interpreted as two 16-bit fields.
Bits (0:16) comprise
status.info . A negative value indicates an error
condition, and a positive value indicates a warning condition. Refer to the
MPE/iX Error Message Manual Volumes 1, 2 and 3 for a description of its
value.
Bits (16:16) comprise
status.subsys . The value represented by these bits
defines the subsystem that set the status information. The subsystem
identifier for HPUNLOADCMPROCEDURE is 105.