MPE/iX Commands Reference Manual (32650-90877)

Chapter 13 581
Command List XI
Commands SHOWLOG thru STORE
equation would be:
:FILE MYDISC=DISCBACK.DAILY.BACKUP;DEV=DISC
Note that DEV=DISC must be specified for STORE to recover files from disk
backups. All other information in the file equation will be ignored by
STORE. STORE creates a binary, fixed record file containing the backup data.
This disk file can be restored using the same file equation for RESTORE.
By default, STORE creates the disk file with a 4Gig limit. If the data being
stored exceeds this, or an existing file with a smaller limit is specified for
the backup, then STORE will create and write to additional disk files. It will
append the "reel" number to the disk file name originally specified. For
example, if the backup disk file specified was /SYS/BACKUPS/DAILY, and
STORE ran out of room, it would create /SYS/BACKUPS/DAILY.2,
/SYS/BACKUPS/DAILY.3, and so on. The additional files are HFS-named
files.
TurboSTORE/iX 7x24 True-Online Backup must be used to create disk
backups.
SHOW Specifies that STORE is to report information for every file that is stored. If
you omit the SHOW parameter, then only the names of the files not stored
are listed, along with the number of files stored and the number of files not
stored. This listing is sent to $STDLIST (formal file designator SYSLIST)
unless a FILE command is entered to send the listing to some other device.
For instance, if you enter the following file equation before issuing the
STORE command, the listing will be sent to a line printer.
FILE SYSLIST; DEV=LP
showparmlist Tells STORE what information to display for the files that are stored. If you
specify ;SHOW and omit
showparmlist , then the default is SHORT if the
recordsize of SYSLIST is less than 132 characters, or LONG if the recordsize
is equal to or greater than 132 characters. The format for
showparmlist
is:
showparm [, showparm [, showparm [,...]
where showparm may be one of the options described below.
If an HFS-named file is specified in the
filesetlist , or the expansion of a
wildcard includes an HFS-named file, then an HFS-style output listing
will be used. This listing shows the same information as the MPE format,
but puts the name of the file at the right end of the listing to allow for
longer HFS names. If an HFS name is too long to fit in the record size of
the output file, it will be wrapped onto the next line. Wrapping is signified
by a "*" as the last character on the line.
showparm SHORT Overrides a default of LONG and displays file name, group
name, account name or the fully qualified path name,
volume restrictions, file size (in sectors), file code, and
media number.
LONG Overrides a default of SHORT and displays all the
information that SHORT does and adds record size, blocking