Setup and Install

in the database of an LDAP server by using settings that are specific to the LDAP server. If either
step fails, the user is denied access to the Digital Sending features. These two steps utilize two
distinct technologies (an authentication server and an LDAP server), except in the case of the LDAP
server method, where both steps are accomplished by using the LDAP server. To enable
authentication, start by selecting an option from the Authentication drop-down list. The following
options are available.
●
None
●
Microsoft Windows
●
LDAP server
●
Novell NDS (if Novell client software is present)
LDAP Configuration
After selecting the authentication method on the Authentication tab, the LDAP configuration settings
appear. The device uses LDAP to retrieve the e-mail address for the authenticated user. After the
user has provided valid credentials, the software uses this information to match an attribute in the
LDAP database. After the match is made and the user is identified in the database, the user’s e-mail
address is retrieved by using another database attribute. The LDAP settings include the following
options.
●
Options for configuring DSS to gain access to the LDAP server
● Options for searching the database to obtain user e-mail addresses
To configure the LDAP server
1. Click Find Servers. The program searches the network for LDAP servers, and might also
prompt you for your network username and password, depending on the network configuration.
Next, the Select LDAP Server dialog box appears, containing a list of LDAP servers on the
network.
NOTE: The Find Servers option for finding LDAP servers does not work in all environments. If
the Find Servers process does not work, the TCP/IP address or hostname of the Domain
Controller or Global Catalog Server should be typed in the LDAP Server text box. If the Global
Catalog Server is used, the default LDAP port in the Port text box must be changed to 3268.
2. Select the LDAP server to use. The information about the selected server appears.
3. Click OK to accept the selected server. The server information is filled in on the Authentication
tab.
4. Click Find Settings. The server settings appear in a dialog box. Click Yes to accept the settings.
5. Click Test on the Authentication tab to test the settings. In the Test User Authentication
dialog box, type in the network logon credentials of a user in order to test whether the user can
be authenticated and whether LDAP can successfully retrieve an e-mail address.
ENWW
Configuration
77