HP Superdome 2 Partitioning Administrator Guide

ManualsBrandsHP ManualsSoftwareHP nPartitions (nPars) and Partition Manager (parmgr) Software

After you power on the partition, the nPartition is booted and comes up to the Active/EFI state

if the nPartition is in nPars mode or to Active/RUN_VPARS state if the nPartition is in vPars

mode.

parstatus -P

[Partition]

Par State/ Status* # of # of ILM/ Partition Name

Num RunState Blades IOBays SLM (first 15

(GB)** characters)

=== ======================= ======= ====== ====== ============= ===============

1 Inactive /DOWN OK 1 0 0.0/0.0 nPar0001

2 Active /RUN_VPARS OK 2 2 2.0/28.0 nPar0002

3 Active /EFI OK 1 2 2.0/28.0 hard_partition

4 Inactive /DOWN OK 0 0 0.0/0.0 nPar0004

5 Inactive /DOWN OK 0 0 0.0/0.0 nPar0005

* D-Degraded

** Actual allocated for Active and User requested for Inactive partitions

The bo command without arguments prompts you to select a partition to boot:

boThis command controls power enable to a partition.

Partition Partition

Number Name

--------- ---------

1 nPar0001

1:1 nPar0001:vPar1

1:2 nPar0001:vPar0002

1:3 nPar0001:we

1:5 nPar0001:vPar0005

1:21 nPar0001:vPar0021

2 nPar0002

2:1 nPar0002:vPar0001

3 hard_partition

4 nPar0004

5 nPar0005

Q) Quit

Select partition number:2:1

Poweron request sent to partition 2:1.

Operation initiated successfully.

Please run PARSTATUS/VPARSTATUS or SHOW SYSLOG OA to determine the completion

status of the operation.

The pe command prompts you to select a partition:

This command controls power enable to a partition.