HP LineJet Printers - PCL-II/LinePrinter Plus Technical Reference Manual, 171249-001PX

146
Chapter 4 Configuring the Proprinter III XL Emulation with Control Codes
Print Next Character
ASCII Code ESC ^ n
Hex Code 1B 5E n
Dec Code 27 94 n
Purpose Prints the graphic character assigned to n , rather than
interpreting the code value as a command.
Discussion This command may appear anywhere in the data stream, and
will be acted upon immediately. Valid numerical parameters are
in the range 0 through 255 (hex 00 through hex FF).
Print Mode
ASCII Code ESC I n (uppercase “i”)
Hex Code 1B 49
n
Dec Code 27 73 n
Purpose Selects a print mode.
Discussion This control code selects a print mode from among the choices
listed in Table 33.
There are several duplicate function values that select the same
print quality. These are provided for compatibility with the
Proprinter III XL standard.
Table 33. Print Mode Values
n Hex Function
00 DP 10 cpi
01 HS 12 cpi
02 NLQ Sans Serif 10 cpi
03 NLQ 10 cpi
04 DP 10 cpi
05 HS 12 cpi
06 NLQ Sans Serif 10 cpi
07 NLQ 10 cpi
0B NLQ Italic Proportional
0F NLQ Italic 10 cpi
Note If you specify any value other than the ones shown in Table
33, unpredictable results may occur.