Operation Manual

52 Basics of operation
2.1 General information on operation
2.1 General information on
operation
Operation
 Select the desired operating mode with the corresponding operating
mode key.
 Within the operating mode, you can change the mode through the
soft keys.
 With the numeric keypad you can select the function within the
menus.
 Dialogs can consist of multiple pages.
 Besides with the soft keys, dialogs can be concluded positively with
"INS" or negatively with "ESC."
 Changes made in lists are effective immediately. They are also
saved if the list is closed with "ESC" or "Cancel."
Setup
 You will find all setup functions in the machine mode in "Manual
mode."
 All preparatory work can be performed through the "setup" menu
item and "Set S,F,T."
Programming – Teach-in mode
 Select Teach-in in the "machine" mode and use the Program list
soft key to open a new cycle program.
 Activate the cycle menu through the Add cycle soft key. Here you
select the operation and enter the details.
 Then press the Input finished soft key. Now you can start the
simulation and check the machining process.
 Start the operation in the machine with "Cycle on."
 Save that cycle after the operation is completed.
 Repeat the last steps for each new operation.
Programming – smart.Turn
 Convenient programming with UNITS in a structured NC program.
 Combinable with DIN functions.
 Contour definition is graphically possible.
 Contour follow-up when used with a workpiece blank.
 Conversion of cycle programs to smart.Turn programs with the
same functions.