User Manual

35
Recording
When connected to your computer using the USB Type-B Port, you can select and use the
HeadRush Looperboard as a 24-bit audio interface, enabling you to play audio through it or send its
audio signal to your computer. The HeadRush Looperboard can operate at sample rates of 44.1, 48,
88.2 or 96 kHz.
Important Note for Windows Users: Before connecting HeadRush Looperboard to your computer,
download and install the necessary drivers from headrushfx.com/support.
To use HeadRush Looperboard as an audio interface:
1. Use a standard USB cable to connect HeadRush Looperboard's USB Type-B Port to an
available USB port (type-A) on your computer.
2. With your computer already powered on, power on HeadRush Looperboard using the power
switch.
3. Tap the ••• icon in the upper-right corner of the touchscreen, and then tap Global Settings.
4. Under USB Audio, set Enable to On.
5. On your computer, open the Control Panel (Windows
®
) or System Preferences (macOS
®
)
menu.
6. Open the sound or audio settings, and then select HeadRush Looperboard as the device for
recording/input and/or for playback/output.
The HeadRush Looperboard will send a stereo audio signal to your computer. This stereo audio
signal mirrors your analog master outputs 1 and 2, and can be selected as an input in your digital
audio workstation (DAW).
The HeadRush Looperboard will also receive a stereo audio signal from your computer. The
channels are named and routed directly out of the HeadRush Looperboard’s master outputs and
phones output. You can adjust the level of the incoming audio signal in the Global Settings.