Installation Guide

Set the Return Panel in place.
Place the ⅛" rubber block on the floor 3" from the wall.
Place a ⁄" rubber block inside the floor clip. Rubber
blocks are not required in the wall clips.
Carefully place the Return Panel on the rubber blocks
and slot it into the wall clips. Partially tighten screws.
Use a level on the outer-edge to ensure the fixed panel
is level and in line.
05
Tip: Use additional rubber blocks on
either existing blocks to raise/drop
the Fixed Panel if required.
Place Slider Panel inside shower.
Place Slider Panel inside the shower on cardboard
to protect the boom of door. Be sure to face handle
holes toward Return Panel. This will make it easier for
installation at later stage once Fixed Panel and bar has
been set in place.
06