Instructions / Assembly

ManualsBrandsFREEMOTION ManualsCardio Equipment645 Elliptical

MAINTENANCE

Inspect and tighten all parts of the elliptical regularly.

Replace any worn parts immediately.

To clean the elliptical, use a damp cloth and a small

amount of mild soap. IMPORTANT: To avoid damage

to the console, keep liquids away from the console

and keep the console out of direct sunlight.

CONSOLE TROUBLESHOOTING

If the console does not turn on, make sure that the

power cord is fully plugged in.

If lines appear in the console display, see HOW TO

CHANGE CONSOLE SETTINGS on page 22 and

adjust the contrast level of the display.

If the console does not display your heart rate when

you hold the handgrip heart rate monitor, or if the dis-

played heart rate appears to be too high or too low, see

step 5 on page 18.

HOW TO GREASE THE ROLLERS

See the EXPLODED DRAWING near the end of this

manual. If the Large Rollers (51) squeak when mov-

ing on the Tracks (11), ﬁ rst clean the Tracks and the

Large Rollers with a lint-free cloth and rubbing alcohol.

Next, apply one packet (3 grams) of the included PTFE

grease to each Track. Use a lint-free cloth or your

ﬁ ngers to spread the grease evenly along the Tracks.

Then, wipe off any excess grease. If the included

grease packets have been used or lost, use a high-

quality clear or white grease instead.

HOW TO CALIBRATE THE RAMP

If the ramp is not functioning properly, the ramp may

need to be calibrated. To calibrate the ramp, press and

hold the small fan button for several seconds until the

test mode appears in the display.

Next, press the small fan button again. Then, press

the Ramp increase or decrease button to calibrate the

ramp. The ramp will move upward and downward as it

calibrates.

When the ramp stops moving, the ramp is calibrated.

Then, press the small fan button repeatedly to exit the

calibration mode.

HOW TO ADJUST THE REED SWITCH

If the console does not display correct feedback, the

reed switch should be adjusted. To adjust the reed

switch, first unplug the power cord.

Next, use a flat

screwdriver

and carefully

pry the left Disc

Cover (55) off

the left Disc

(71).

Next, turn the left Crank Arm (20) until one of the

Magnets (43) on the Pulley (19) is aligned with the

Reed Switch (38). Then, loosen, but do not remove,

the two M4 x 16mm Screws (104), slide the Reed

Switch slightly closer to or away from the Magnet, and

retighten the Screws.

Then, plug in the power cord and turn the left crank

arm for a moment. Repeat the procedure above, if

necessary, until the console displays correct feedback.

Then, reattach the left disc.

MAINTENANCE AND TROUBLESHOOTING

104