USE & CARE MANUAL DISHWASHER MODEL : COS-DIS6502
TABLE OF CONTENTS IMPORTANT SAFE GUARDS..................................................................1 SPECIFICATIONS....................................................................................2 FEATURES OF YOUR NEW DISHWASHER...........................................3 OPERATING THE CONTROL PANEL.........................................5 INSTALLATION REQUIREMENTS..........................................................7 ENCLOSURE REQUIREMENTS.................................................
Please install your dishwasher properly and follow the installation guide. - Water supply temperature should be 120℉ or 149℉. - Dispose of the discarded appliance and packing material properly. - The dishwasher must be grounded, or it can result in a risk of electric shock. - If there is any damage to the dishwasher, please contact to your retailer. Do not attempt to repair or replace any part by yourself. 1. Read all instructions before using the dishwasher. 2.
SPECIFICATIONS Capacity: 14 place settings Dimensions (W x D x H): 23.9 x 25.6 x 33.7 in. Weight: 94 lbs Power Supply: 120 volts, 60 Hz Rated Power Usage: Wash Motor: 50W, Heater: 840W Water Feed Pressure: 20 ~ 120 psi 1. Top Light 2. Upper Spray Arm 3. Middle Spray Arm 4. Vortex Wash Arm 5. Low Spray Arm 6. Rinse Aid Dispenser 7. Detergent Dispenser 8. Cup Shelf 9. Adjustable Upper Rack 10. Tub Gasket 11. Silverware Basket 12. Bottom Rack 13.
FEATURES OF YOUR NEW DISHWASHER Filter System Your dishwasher has a multiple Filter System. In the Filter System, there are four filter-meshes. It can separate soiled water and clean water in different chambers. The multiple filter system helps your dishwasher to get better performance with less water and less energy. Adjustable Upper Rack The Upper Rack can be raised or lowered to accommodate loading taller dishes in either rack. The Upper Rack clearance height H1 goes from 8" to 10".
How Your Dishwasher Cleans Getting Started Your dishwasher cleans by spraying a 1. Load dishwasher. mixture of hot water and detergent through 2. Add detergent. the spray arms against soiled surfaces. 3. Add rinse aid, if needed. 4. Close door latch. The dishwasher fills with water covering the 5. Select desired CYCLE. The indicator light filter area. Water is then pumped through above the touchpad will glow when the multiple filter and spray arms. Soiled selected.
, 11. HEATING DRY be 12. SANITIZED 13.
Cycle Progress Indicator ight Wash Dry Clean Page 6
INSTALLATION REQUIREMENTS Page 7
Enclosure Requirements • The cabinet opening must be at least 24 in. wide. • The maximum height of the opening is 35 in. • The dishwasher must be installed so that the drain hose is no more than 10 feet in length, for proper drainage. • The dishwasher must be fully enclosed on the top, sides, and back, and must not support any part of the enclosure. If installing into a corner, allow 2 in. min. clearance between dishwasher and adjacent cabinet, wall, or other appliances. Allow 25-5/8 in. min.
Drain Requirements • Follow all local codes and ordinances. • Do not exceed 10 ft. of drain hose. • Do not connect the drain lines from other devices to the dishwasher drain hose. • The dishwasher must be connected to a waste line with an air gap (not provided) or a 32 in. high (min.) drain loop, depending on local codes and ordinances, to prevent back flow into the dishwasher. • An air gap must be used if the waste tee or garbage disposal connection is less than 18 in.
Electrical Requirements - This appliance must be supplied with 120V, 60 Hz., and connected to its own, properly grounded branch circuit, protected by a 15 or 20 ampere circuit breaker or time delay fuse. - Wiring must be two wire with ground. - If the electrical supply does not meet the above requirements, call a licensed electrician before proceeding.
Cable direct connections may pass through the same hole as the drain hose and hot water line, but power cords with plugs must pass through a separate hole. Preparing the Hot Water Line - The water connection is on the left side of dishwasher. - The hot water line may enter the opening from either side, the rear, or the floor within the shaded area. - The hot water line may pass through the same hole as the electrical and drain hose. Or, you can drill an additional 1-1/2 in.
IINSTALLATION INSTRUCTIONS Step 1: Check the door balance 1. Hold the top of the dishwasher firmly. 2. Open the door slowly, then release it. If the door drops, increase the spring tension. If the door closes, decrease the spring tension. 3. Continue moving the spring pin until the door is balanced. Adjust both springs to the same tension. Step 2: Adjust the leveling legs 1. Move the dishwasher close to the installation location and lay it on its back. 2.
Step 4: Install the power cord Skip this step if the dishwasher will be direct wired. 1. Remove the junction box cover on the right front of the dishwasher. 2. Connect the incoming white (or ribbed) wire to the dishwasher’s white wire, the black (or smooth) wire to the dishwasher’s black wire, and the ground wire to the dishwasher’s green wire. Use cUL/UL listed wire nuts of the appropriate size. 3. Replace the junction box cover on the right front of the dishwasher.
Step 6: Install the drain hose 1. Turn the dishwasher upright. 2. Slide a screw-type hose clamp onto the drain hose. 3. Install the drain hose to the dishwasher drain outlet on the back of the dishwasher, then tighten the screw-type hose clamp. Use Philips screwdriver, screw-type hose clamps, and drain hose. Step 7: Inserting the drain hose through the cabinet Insert the drain hose into the hole in the cabinet wall. If a power cord is used, guide the end through a separate hole.
Step 9: Position the dishwasher under the countertop 1. Make sure that the wires are secure under the dishwasher and not pinched or in contact with door springs or other dishwasher components. TIP: Check tub insulation blanket, if equipped. It should be positioned so it is not bunched up or interfering with door springs. Check by opening and closing the door. 2. Push the dishwasher into the cabinet. The front corners of the dishwasher door should be flush with the cabinet doors.
Step 11: Securing the dishwasher to the countertop - For countertops made of wood or materials that won’t be damaged by drilling, use Method 1. - For countertops made of granite, marble, or other materials that could be damaged by drilling, use Method 2. - If the gap between the control panel and the cabinet is less than 0.4 in. (10 mm), use Method 2. Method 1 1. Insert the long top mounting clips into the slot. 2. Bend the brackets to secure them to the dishwasher tub. 3.
Step 12: Connecting the water supply line 1. Slide the compression nut, then the ferrule over the end of the water supply line. 2. Insert the water supply line into the 90° elbow. 3. Slide the ferrule against the 90° elbow and secure it with the compression nut. IMPORTANT: Make sure that the door spring does not rub or contact the water supply line or drain hose. Test by opening and closing the door. Reroute the lines if interference occurs.
Step 14: Connecting the electrical power Turn off the electricity to the dishwasher’s electrical circuit. Skip this step if your dishwasher is equipped with a power cord. Make sure that the electrical power is turned off at the source. 1. Remove the junction box cover from the power supply junction box on the wall. 2. Locate the three dishwasher wires, (white, black, and green) with stripped ends, then insert the dishwasher wires through the small hole in the junction box. 3.
Step 15: Performing a pre-test check - Make sure that power is turned OFF. - Open the door and remove all foam and paper packaging. - Check the door opening and closing. If the door does not open and close freely, or tends to fall, check the spring adjustments. See “Step 1: Check the door balance”. - Make sure that the wiring is secure under the dishwasher and not pinched or in contact with door springs or other components. See “Step 9: Position the dishwasher under the countertop”.
PARTS LIST Page 20
Page 21
Page 22
EXPLODED VIEW Page 23
Page 24
Page 25
Page 26
Page 27
Page 28
Page 29
Page 30
WARRANTY AND SERVICE For full warranty details on this product please visit: http://www.cosmoappliances.
