Charger Manual

3
EN
PRODUCT SAFETY
IMPORTANT SAFETY
INSTRUCTIONS
Save these instructions - this manual contains
important safety and operating instruction for battery
charger models___DG6C3/DG6C5__.
DANGER – to reduce the risk of re or electric shock,
carefully follow these instructions
Before using battery charger, read all instructions and
cautionary markings on battery charger, battery, and
product using battery.
WARNING: This product can expose you to
chemicals including lead and Di(2-ethylhexyl)
phthalate (DEHP) which are known to the State of
California to cause cancer and birth defects or other
reproductive harm. For more information go to www.
P65Warnings.ca.gov.
WARNING:
1. WARNING–To reduce the risk of re and electric
shock, install in a temperature- and humidity-
controlled indoor area relatively free of conductive
contaminants.
2. CAUTION–To reduce the risk of re and electric
shock, remove battery charger from the
receptacle when not in use.
3. WARNINGTo Avoid Electric Shock –Do not
touch exposed live terminals or connected parts.
4. CAUTION–For continued protection against risk
of re, replace only with same type and ratings of
fuse.
5. CAUTION–To reduce the risk of re, use only on
circuits provided with _3 A (DG6C3)/5 A(DG6C5)_
branch-circuit protection in accordance with the
National Electrical Code, ANSI/NFPA 70.
6. CAUTION–For use indoor only. To reduce the risk
of re and electric shock, do not expose to liquid,
vapor, or rain.
7. CAUTION–Disconnect supply before changing
fuse.
8. CAUTION–To reduce risk of injury, charge
only _DG6B2,DG6B25,DG6B4,DG6B5___ type
rechargeable batteries. Other types of batteries
may burst causing personal injury and damage.
9. This battery charger is intended to be correctly
orientated in a vertical or oor mount position.
10. Disconnect power to the receptacle before
installing or removing the unit. When removing
receptacle cover screw, cover may fall across
plug pins or receptacle may become displaced.
11. Use only with duplex receptacle having center
screw.
12. Secure unit in place by receptacle cover screw.
13. To reduce the risk of re and electric shock, do not
replace this plug assembly.
SAVE THESE INSTRUCTIONS
INFORMATION FOR RADIATED
EMISSION
This device complies with Canadian ICES-001.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference,
and
(2) this device must accept any interference received,
including interference that may cause undesired
operation.
Warning: Changes or modications to this unit
not expressly approved by the party responsible
for compliance could void the user’s authority to
operate the equipment.
- NOTE: This equipment has been tested and found
to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in a residential
installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may
cause harmful interference to radio communications.
However, there is no guarantee that interference will
not occur in a particular installation. If this equipment
does cause harmful interference to radio or television
reception, which can be determined by turning the
equipment off and on, the user is encouraged to try
to correct the interference by one or more of the
following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment
and receiver.
Connect the equipment into an outlet on a circuit
different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/TV
technician for help.