User Manual v12.1.0 Instruction Manual

108 Brocade Network Advisor SAN + IP User Manual
53-1002949-01
IP discovery profiles
4
Editing address ranges
NOTE
DCB devices discovered through Fabric discovery (from the SAN tab) are automatically added to IP
discovery during rediscovery.
1. Select Discover > IP Products.
The Discover Setup - IP dialog box displays.
2. Click the Profiles tab
3. Select the profile you want to edit in the Discovery Profiles table and click the Address Ranges
tab.
4. To edit an included address range, select the address range you want to edit in the Included IP
Addresses list.
5. Click the left arrow button to display the address range details in the top Add/Edit IP Addresses
area.
6. Edit the included address range by choosing one of the following options:
• To edit the included addresses using the CIDR subnet format, refer to “Editing CIDR subnet
addresses” on page 109.
• To edit the included addresses using the subnet format, refer to “Editing subnet
addresses” on page 109.
• To edit the included addresses using the address range format, refer to “Editing IP
addresses” on page 109.
7. Select the Also perform ping sweep check box to perform ping sweep on the address range.
8. To edit an excluded address range, select the address range you want to edit in the Excluded IP
Addresses list.
9. Click the left arrow button to display the address range details in the bottom Add/Edit IP
Addresses area.
10. Edit the excluded address range by choosing one of the following options:
• To edit the excluded addresses using the CIDR subnet format, refer to “Editing CIDR
subnet addresses” on page 109.
• To edit the excluded addresses using the subnet format, refer to “Editing subnet
addresses” on page 109.
• To edit the excluded addresses using the address range format, refer to “Editing IP
addresses” on page 109.
NOTE
DCB products discovered through Fabric discovery (on the SAN tab) cannot be excluded.
11. Click the right arrow button to add the address range to the Excluded IP Addresses list.
12. Click Apply to save your changes.
13. Click Close to close the Discover Setup - IP dialog box.
14. Click Yes on the confirmation message.