Installation Guide

English 16

With the drawer removed, set the slide inner rail to the

drawer locked position by pushing the slide inner rail

toward the rear of the housing until it locks in place.

Note: A moderate force pushing on the black plastic

ball carrier locking mechanism is required to set the

slide to the drawer locked position. The drawer is

locked when it remains in place and does not spring

back to the open position.

Position the drawer assembly in front of the housing

assembly and align the rail (plastic rail tip) to the slide

ball carrier assembly. Keeping the drawer assembly

level and square to the housing, gently insert the

drawer to the housing assembly.

Notes

▯ A slight side-to-side wiggle motion may be required

to properly get the ball bearings to accurately align.

▯ Remember: You are attempting to align two sets of

ball bearings at this point. If more than a moderate

force is required to insert the drawer at this time,

remove the drawer and repeat the installation

procedure to this point.

Continue to insert the drawer keeping the drawer level

and square to the housing until a slight increase in

resistance is felt at the approximate position shown

below.

4MJEF*OOFS3BJM

-PDLJOH.FDIBOJTN

4MJEF*OOFS3BJMJTJOMPDLFEQPTJUJPO

NOTICES

▯ At this position, a slight increase in closure force is

required with several small increments of force

applied to the drawer to accurately align and set the

drawer for proper operation.

▯ An audible “click” should be heard when the drawer

is properly closed causing the drawer to lock in the

closed position.