User's Manual

Chapter 4 ZyXEL Utility Configuration

G-210H User’s Guide

The following table describes the labels in this screen.

4.5.1 WMM Advanced Setting

Click Enable WMM in the Adapter screen to configure advanced WMM settings.

Table 15 Adapter

LABEL DESCRIPTION

Adapter Setting

Transfer Rate In most networking scenarios, the factory default Auto setting is the most efficient

and allows your G-210H to operate at the highest possible transmission (data)

rate.

If you want to select a specific transmission rate, select one that the AP or peer

wireless device supports.

Wireless Mode Select 802.11 B/G mixed to have the G-210H connect to either an IEEE 802.11g

or IEEE 802.11b wireless device.

Select 802.11 B only to have the G-210H connect to an IEEE 802.11b wireless

device only.

11B/G Protection Enabling this feature can help prevent collisions in mixed-mode networks

(networks with both IEEE 802.11b and IEEE 802.11g traffic).

Select Auto to have the G-210H send an RTS (Request to Send) message to the

AP and wait for AP’s CTS (Clear to Send) response before transmitting data when

the G-210H is connecting to an AP with this feature enabled.

Select On to have the G-210H always transmit data after a RTS/CTS handshake

even when the G-210H is connecting to an AP with this feature disabled.

Select Off to disable 11B/G protection.

Enable Tx Burst Select the check box to increase the throughput and improve transmission speed.

This only works when an AP or peer device supports this function.

Fast Roaming at When the signal strength is too low, you may want to connect to a closer AP. Fast

roaming allows you to connect to the closer AP without interrupting the wireless

connection.

Select the check box to enable fast roaming at the specified transmitting power.

The G-210H will enter roaming mode when dBm reaches a certain level.

Disable WMM/

Enable WMM

WMM (Wi-Fi MultiMedia) QoS (Quality of Service) allows you to prioritize wireless

traffic according to the delivery requirements of individual services. To do this, you

must enable WMM QoS on all wireless devices in your network.

Click Disable WMM to deactivate WMM QoS on the G-210H.

Click Enable WMM to activate WMM QoS on the G-210H and display the WMM

Advanced Setting screen.

Save Click Save to save the changes to the G-210H.