User's Manual

Chapter 52 System
ISG50 User’s Guide
700
The following table describes the labels in this screen.
52.11 SNMP
Simple Network Management Protocol is a protocol used for exchanging management information
between network devices. Your ISG50 supports SNMP agent functionality, which allows a manager
station to manage and monitor the ISG50 through the network. The ISG50 supports SNMP version
Table 279 Configuration > System > FTP
LABEL DESCRIPTION
Enable Select the check box to allow or disallow the computer with the IP address that
matches the IP address(es) in the Service Control table to access the ISG50
using this service.
TLS required Select the check box to use FTP over TLS (Transport Layer Security) to encrypt
communication.
This implements TLS as a security mechanism to secure FTP clients and/or
servers.
Server Port You may change the server port number for a service if needed, however you
must use the same port number in order to use that service for remote
management.
Server
Certificate
Select the certificate whose corresponding private key is to be used to identify the
ISG50 for FTP connections. You must have certificates already configured in the
My Certificates screen (Click My Certificates and see Chapter 50 on page 643
for details).
Service Control This specifies from which computers you can access which ISG50 zones.
Add Click this to create a new entry. Select an entry and click Add to create a new
entry after the selected entry. Refer to Table 275 on page 683 for details on the
screen that opens.
Edit Double-click an entry or select it and click Edit to be able to modify the entry’s
settings.
Remove To remove an entry, select it and click Remove. The ISG50 confirms you want to
remove it before doing so. Note that subsequent entries move up by one when
you take this action.
Move To change an entry’s position in the numbered list, select the method and click
Move to display a field to type a number for where you want to put it and press
[ENTER] to move the rule to the number that you typed.
# This the index number of the service control rule.
The entry with a hyphen (-) instead of a number is the ISG50’s (non-configurable)
default policy. The ISG50 applies this to traffic that does not match any other
configured rule. It is not an editable rule. To apply other behavior, configure a rule
that traffic will match so the ISG50 will not have to use the default policy.
Zone This is the zone on the ISG50 the user is allowed or denied to access.
Address This is the object name of the IP address(es) with which the computer is allowed
or denied to access.
Action This displays whether the computer with the IP address specified above can
access the ISG50 zone(s) configured in the Zone field (Accept) or not (Deny).
Apply Click Apply to save your changes back to the ISG50.
Reset Click Reset to return the screen to its last-saved settings.