User's Manual

Chapter 5 Internet and Wireless Setup Wizard

AMG1202-T10A User’s Guide

3 Configure your wireless settings in this screen. Click Next.

Figure 24 Wireless LAN

The following table describes the labels in this screen.

Note: The wireless stations and ZyXEL Device must use the same SSID, channel ID and

WEP encryption key (if WEP is enabled), WPA-PSK (if WPA-PSK is enabled) for

wireless communication.

4 This screen varies depending on the security mode you selected in the previous screen. Fill in the

field (if available) and click Next.

Table 13 Wireless LAN Setup Wizard 2

LABEL DESCRIPTION

Network

Name(SSID)

Enter a descriptive name (up to 32 printable 7-bit ASCII characters) for the wireless

LAN.

If you change this field on the ZyXEL Device, make sure all wireless stations use the

same SSID in order to access the network.

Channel

Selection

The range of radio frequencies used by IEEE 802.11b/g wireless devices is called a

channel. Select a channel ID that is not already in use by a neighboring device.

Security Select Manually assign a WPA-PSK key to configure a Pre-Shared Key (WPA-

PSK). Choose this option only if your wireless clients support WPA. See Section 5.3.1

on page 66 for more information.

Select Manually assign a WEP key to configure a WEP Key. See Section 5.3.2 on

page 66 for more information.

Select Disable wireless security to have no wireless LAN security configured and

your network is accessible to any wireless networking device that is within range.

Back Click this to return to the previous screen without saving.

Next Click this to continue to the next wizard screen.

Exit Click this to close the wizard screen without saving.