User's Manual

Chapter 8 Wireless LAN
AMG1202-T10A User’s Guide
100
8.2.1 No Security
In the Network > Wireless LAN > AP screen, select No Security from the Security Mode list to
allow wireless devices to communicate with the ZyXEL Device without any data encryption or
authentication.
Note: If you do not enable any wireless security on your ZyXEL Device, your network is
accessible to any wireless networking device that is within range.
Figure 44 Network > Wireless LAN > AP: No Security
The following table describes the labels in this screen.
8.2.2 WEP Encryption
Use this screen to configure and enable WEP encryption. Click Network > Wireless LAN to display
the AP screen. Select Static WEP from the Security Mode list.
Edit Click this to go to the MAC Filter screen to configure MAC filter settings. See
Section 8.2.6 on page 106 for more details.
QoS Select this check box to activate Quality of Service (QoS).
Apply Click this to save your changes.
Cancel Click this to restore your previously saved settings.
Advanced
Setup
Click this to display the Wireless Advanced Setup screen and edit more details of
your WLAN setup. See Section 8.2.5 on page 104 for more details.
Table 26 Network > Wireless LAN > AP
LABEL DESCRIPTION
Table 27 Network > Wireless LAN > AP: No Security
LABEL DESCRIPTION
Security Mode Choose No Security from the drop-down list box.