User's Manual

Chapter 2 Introducing the Web Configurator
P-793H User’s Guide
50
2.4.1 Status: Bandwidth Status
This is the same screen discussed in Figure 97 on page 190.
VPI/VCI This is the Virtual Path Identifier and Virtual Channel Identifier that you entered in
the Wizard or WAN screen.
LAN Information
IP Address This is the LAN port IP address.
IP Subnet Mask This is the LAN port IP subnet mask.
DHCP This is the WAN port DHCP role - Server, Relay or None.
Security This section is not available if you use the user password to log in.
Firewall This displays whether or not the ZyXEL Device’s firewall is activated.
Content Filter This displays whether or not the ZyXEL Device’s content filtering is activated.
System Status
System Uptime This is the total time the ZyXEL Device has been on.
Current Date/Time This field displays your ZyXEL Device’s present date and time.
System Mode This displays whether the ZyXEL Device is functioning as a router or a bridge.
CPU Usage This number shows how many kilobytes of the heap memory the ZyXEL Device
is using. Heap memory refers to the memory that is not used by ZyNOS (ZyXEL
Network Operating System) and is thus available for running processes like NAT,
VPN and the firewall.
The bar displays what percent of the ZyXEL Device's heap memory is in use. The
bar turns from green to red when the maximum is being approached.
Memory Usage This number shows the ZyXEL Device's total heap memory (in kilobytes).
The bar displays what percent of the ZyXEL Device's heap memory is in use. The
bar turns from green to red when the maximum is being approached.
Interface Status
Interface This displays the ZyXEL Device interfaces.
Status This field displays Down (line is down), Up (line is up or connected) if you're
using Ethernet encapsulation and Down (line is down), Up (line is up or
connected), Idle (line (ppp) idle), Dial (starting to trigger a call) and Drop
(dropping a call) if you're using PPPoE encapsulation.
Rate For the LAN ports, this displays the port speed and duplex setting. Ethernet port
connections can be in half-duplex or full-duplex mode. Full-duplex refers to a
device's ability to send and receive simultaneously, while half-duplex indicates
that traffic can flow in only one direction at a time. The Ethernet port must use the
same speed or duplex mode setting as the peer Ethernet port in order to connect.
Simultaneous transmissions over the same port (Full-duplex) essentially double
the bandwidth.
For the WAN port, it displays the downstream and upstream transmission rate.
This is displayed for both DSL 1 and DSL 2 connections.
Summary This section is not available if you use the user password to log in.
Bandwidth Status Use this screen to view the ZyXEL Device’s bandwidth usage and allotments.
Packet Statistics Use this screen to view port status and packet specific statistics.
VPN Status Use this screen to view the status of any VPN tunnels the ZyXEL Device has
negotiated.
Table 3 Status (continued)
LABEL DESCRIPTION