User's Manual

P-793H User’s Guide
309
CHAPTER 31
SNMP Configuration
Use this menu to configure SNMP. See Section 15.6 on page 199 for more information about
SNMP.
31.1 SNMP Configuration
To configure SNMP, enter 22 from the main menu to display Menu 22 - SNMP
Configuration as shown next. The “community” for Get, Set and Trap fields is SNMP
terminology for password.
Figure 200 Menu 22: SNMP Configuration
The following table describes the SNMP configuration parameters.
Menu 22 - SNMP Configuration
SNMP:
Get Community= public
Set Community= public
Trusted Host= 0.0.0.0
Trap:
Community= public
Destination= 0.0.0.0
Table 118 Menu 22: SNMP Configuration
FIELD DESCRIPTION
Get Community Type the Get community, which is the password for the incoming Get- and GetNext
requests from the management station.
Set Community Type the Set community, which is the password for incoming Set requests from the
management station.
Trusted Host If you enter a trusted host, your ZyXEL Device will only respond to SNMP messages
from this address. A blank (default) field means your ZyXEL Device will respond to
all SNMP messages it receives, regardless of source.
Trap
Community Type the Trap community, which is the password sent with each trap to the SNMP
manager.
Destination Type the IP address of the station to send your SNMP traps to.
When you have completed this menu, press [ENTER] at the prompt “Press [ENTER] to confirm or
[ESC] to cancel” to save your configuration or press [ESC] to cancel and go back to the previous
screen.