Installation Guide

ManualsBrandsZurn ManualsPlumbing Product3.5 gal. AquaVantage Exposed Closet Flush Valve

AquaVantage

Z6000AV Series

AquaVantage Exposed Flushometer

Installation, Operation,

Maintenance, and Parts Manual

Patented and Patents Pending

LIMITED WARRANTY

All goods sold hereunder are warranted to be free from defects in material and factory work man ship for a period of three years from the date of

purchase. Decorative finishes warranted for one year. We will replace at no cost goods that prove defective provided we are notified in writing of such

defect and the goods are returned to us prepaid at Sanford, NC, with evidence that they have been properly maintained and used in accordance with

instructions. We shall not be responsible for any labor charges or any loss, injury or dam ag es whatsoever, including incidental or consequential damages.

The sole and exclusive remedy shall be limited to the re place ment of the defective goods. Before installation and use, the purchaser shall determine

the suitability of the product for his intended use and the purchaser assumes all risk and liability whatever in connection therewith. Where permitted

by law, the implied warranty of mer chant abil i ty is expressly excluded. If the products sold hereunder are “con sum er products,” the implied warranty

of mer chant abil i ty is limited to a period of three years and shall be limited solely to the replacement of the defective goods. All weights stated in our

catalogs and lists are ap prox i mate and are not guaranteed.

AquaVantage

Exposed

Closet/Urinal Systems

Z6000AV

Z6000AV-HET

Z6001AV

Z6003AV

Z6003AV-ULF

Z6010AV

Z6014AV

Z6017AV

Z6096AV

Z6099AV

Z6000AV

Z6003AV

ADA

Summary of content (8 pages)

PAGE 1
AquaVantage AV Z6000AV Series ® AquaVantage Exposed Flushometer Installation, Operation, Maintenance, and Parts Manual Patented and Patents Pending Z6000AV X ADA Z6003AV AquaVantage® Exposed Closet/Urinal Systems Z6000AV Z6000AV-HET Z6001AV Z6003AV Z6003AV-ULF Z6010AV Z6014AV Z6017AV Z6096AV Z6099AV X ADA LIMITED WARRANTY All goods sold hereunder are warranted to be free from defects in material and factory workmanship for a period of three years from the date of purchase.
PAGE 2
AquaVantage® Rough-In, Product Specification, Models, and Options ENGINEERING SPECIFICATION: ZURN AquaVantage ® ‘AV’ Exposed Closet Flush Valve – Exposed, quiet diaphragm type, chrome-plated flushometer valve with a polished exterior. Complete with Zurn’s AquaVantage TPE, chloramine resistant, dual seal diaphragm with a clog resistant, triple filtered by-pass.
PAGE 3
Sweat Solder Adaptor Installation Instructions Important: • All plumbing is to be installed according to state and local codes and regulations. • Water supply lines need to allow proper water flow for each fixture. • Flush all lines of any debris before making connections. • Do not use pipe sealant or plumbing grease on any fitting other than the control stop inlet. STEP NO. 3 Measure from finished wall to first thread of adapter for length of chrome tube. Cut chrome tube this length ‘x’.
PAGE 4
AquaVantage® Installation Instructions 1. Install stop valve assembly using proper size supply escutcheon and sweat solder adapter kit if applicable (see 1). Thread sealing compounds should be used on male NPT threads only. 1 3. Insert the flush valve tailpiece into the stop valve and hand tighten the lock nut to the stop valve. Plumb the entire unit (see 3). 3 2.
PAGE 5
AquaVantage® Installation Instructions 6. When all flush valves are connected to the fixtures and water pressure is available, it is recommended that the supply piping be flushed to remove dirt, pipe chips, etc., from system. Before the water is turned on, be sure all stop valves to the flush valves are closed off tight. The stop valves can be opened and closed by using the adjusting screw located at the center of the stop valve cap, behind the stop cap cover screw if already installed (see 6a).
PAGE 6
AquaVantage® Repair Kits Part Identification 1. Handle Sleeve and Insert 2. Low Force/ADA Compliant Handle 3. Actuator Rod 4. Handle O-Ring 5. Handle Spring 6. Handle Retainer 7. Handle Seal 8. Gasket 9. Valve Body Cover 10. Plastic Cover 11. Trip Mechanism 12. Diaphragm Repair Kit 13. Valve Body 14. Vacuum Breaker Insert 15. Vacuum Breaker Duckbill 16. Vacuum Breaker Tube 17. Vacuum Breaker Tube Nut 18. Spud Nut 19. Spud Friction Washer 20. Spud Sleeve 21. Spud Escutcheon 22. Tailpiece 23. Snap Ring 24.
PAGE 7
AquaVantage® Trouble Shooting Guide Problem Cause* Corrective Action* Valve will not operate. 1.) Stop valve is closed. 1.) Open stop valve. 2.) Supply valve is closed. 2.) Open supply valve. Insufficient volume of water 1.) to adequately siphon fixture. 2.) 3.) Stop valve is not open enough. 1.) Open stop valve for desired volume of water. Urinal trip mechanism installed in wrong kit, 2.) Replace urinal part with proper closet valve part. urinal for closet.
PAGE 8
ZURN INDUSTRIES, LLC COMMERCIAL BRASS OPERATION, 5900 ELWIN BUCHANAN DRIVE, SANFORD, NC, U.S.A. 27330 PHONE: 1-800-997-3876 FAX: 919/775-3541 www.zurn.com ZURN INDUSTRIES LIMITED 3544 NASHUA DRIVE, MISSISSAUGA, ONTARIO L4V 1L2 PHONE: 905/405-8272 FAX: 905/405-1292 © 2011 Zurn Industries, LLC Printed in the U.S.A. Form No. ZMKTG240-58, Rev.