User's Manual

Printer Setup and Operation

Load the Media

P1056468-002 7/3/13

5. Thread the media under the media dancer assembly roller (1), the media guide roller (2),

and then the upper media sensor (

3).

c. Place the roll of media on the media supply

hanger. Push the roll back as far as it will go.

c. Drape the media over the media supply

hanger.

d. Slide in the media supply guide until it

touches the edge of the roll.

d. Slide in the media supply guide until it

touches the edge of the media.

Roll Media (Continued)

Fanfold Media (Continued)

Important • Make sure that you thread the media under these components. If you thread

the media over them, the media obstructs the ribbon sensor and causes a false

RIBBON OUT error.