User's Manual

19
Introduction
Control Panel Display
7/3/13 P1056468-002
Exit Setup Mode
1. At the Idle Display (Figure 3), press SETUP to
enter Setup Mode. The printer displays the first
parameter.
2. While in Setup Mode, press SETUP/EXIT to exit
the operating parameters.
The LCD displays
SAVE CHANGES.
3. To return to the parameters, plus PREVIOUS.
OR
Press PLUS (+) or MINUS (-) to scroll through
the exit options:
• PERMANENT—Stores values in the printer
even when power is turned off.
• TEMPORARY—Saves the changes until
power is turned off.
• CANCEL—This option cancels all changes
made since you entered Setup mode, except
for changes made to DARKNESS, TEAR
OFF, COMMUNICATION, and LANGUAGE
settings, which go into effect as soon as they
are made.
• LOAD DEFAULTS—Use this option to restore
all settings other than the network settings
back to the factory defaults. Use care when
loading defaults because you will need to
reload all settings that you changed manually.
• LOAD LAST SAVE—Loads the values from
the last permanent save.
• DEFAULT NET—Use this option to restore all
print server and network settings back to the
factory defaults. Use care when loading
defaults because you will need to reload all
settings that you changed manually.
4. Press NEXT/SAVE to select the displayed choice
and exit Setup Mode.
When the configuration and calibration sequence
finishes, the printer returns to the Idle Display.
Table 2 • Navigation (Continued)