Owner manual

Parameters: There are 4 valid flow control settings, “None”, “HW”, “SW”, and “Both”.
Response: None, use the FLOWCONTROL? command to see the new value.
Example: -> FLOWCONTROL=HW5 Command sent to the XL™.
rs Response from the XL™.
Command: CHARACTERDELAY?
Description: Read the delay that the XL™ puts between sending characters out the serial
communications port.
Parameters: None.
Response: An ASCII text string is returned with the character delay. The character delay is
and integer between 0 and 999. The response is terminated using a carriage return,
line feed.
Example: -> CHARACTERDELAY?5 Command sent to the XL™.
Character Delay = 0rs Response sent to the host system.
Command: CHARACTERDELAY=XXX
Description: Set the character delay. The character delay is how long the XL™ delays in
milliseconds between sending characters out the serial communications port.
Parameters: This command accepts an integer between 0 and 999.
Response: None, use the CHARACTERDELAY? command to see the new value.
Example: -> CHARACTERDELAY=505 Command sent to the XL™.
rs Response from the XL™.
Command: LINEFEEDELAY?
Description: Read the line feed delay. The XL™ waits this amount of time in milliseconds after
each line feed it sends out the serial communications port.
C-10 Remote Operation (Command Mode) H-5223