Installation Instructions

M Series Microwave Trim Installation
wolfappliance.com 800.222.7820
page 2 of 2
4 Install the bottom duct assembly. The duct must be
recessed back from the front edge of the opening and
offset to the right or left depending on the trim being
installed. The 'LEFT' and 'RIGHT' dimensions are from
the center line of the opening. Refer to the chart below.
Pre drill pilot holes and secure the duct using two screws.
DUCT ASSEMBLY OFFSET
CONVECTION RECESS LEFT RIGHT
Stainless Trim
3
⁄4"
9
⁄16" -
Black Trim
3
⁄4" -
3
⁄8"
STANDARD RECESS LEFT RIGHT
Stainless Trim
1
⁄8" 1" -
Black Trim
1
⁄8" -
3
⁄8"
5 Place the microwave as close to the cabinet opening
as possible and plug the power cord into a properly
grounded electrical outlet.
6 Guide the microwave into the opening and push back.
Align the feet on the microwave with the bottom duct.
7 Align the template with the opening and pre-drill
four 3/16" holes, then install threaded inserts.
Verify the insert is aligned with the cabinet face.
Do not to overtighten.
8 Install the ball studs into the threaded inserts but do not
overtighten. Align the frame assembly with the opening
and press rmly to engage the ball studs.
9 For stainless steel models only, attach the door trim
provided by removing the paper backing from the tape
and aligning the bent ange with the left side of the door.
Press rmly to apply.
RECESSRECESS
TEMPLATE
Align template.
RECESSRECESS
FRAME ASSEMBLY
Attach assembly.
Install microwave.
(Convection microwave shown)
RECESSRECESS
Install bottom duct.