User's Manual

Traditional Style
Pasta Machine Attachments
ALL SOLD SEPARATELY
Traditional Style Pasta Machine 01-0201
Square Ravioli Attachment (50mm) 01-0209
Angel Hair Attachment (1mm) 01-0202
Spaghetti Noodle Attachment (2mm) 01-0203
Linguini Attachment (3mm) 01-0204
Lasagna Attachment (50mm wide) 01-0206
Lasagnette Attachment (12mm wide) 01-0205
Half Moon Ravioli Attachment (50mm) 01-0208
SAVE THESE INSTRUCTIONS!
Refer to them often and use them to instruct others.
ATTENTION!
If any components of this unit are broken, do not operate properly, or for product returns, please
contact Weston Products LLC
Phone: [phone] (Outside the U.S. 440-638-3131)
20365 Progress Drive, Strongsville, Ohio 44149
WestonProducts.com
All Trademarks and Registered Trademarks are property of the respective companies.
These products and many more products can be ordered by visiting
W e s t o n P r o d u c t s . c o m or by calling
Weston Products LLC Toll Free at 1-800-814-4895
Monday thru Friday 8:00am-5:00pm EST. Outside the U.S. call 440-638-3131
REV011911
The Pasta Machine Attachments may have some excess oil on it from the factory. This
is to protect the machine during shipping. THIS OIL MUST BE REMOVED BEFORE
USING THE MACHINE!
.
Using a clean dry cloth, wipe all the surfaces clean. DO NOT USE WATER! Never
wash the Pasta Machine Attachment with water, place it in water, or put it into the
dishwasher. Simply wipe it clean with a dry cloth.
.
To clean the inner surfaces of the Pasta Machine Attachment pass a piece
of dough through the Cutters several times, making sure the dough touches all the
surfaces, especially the sides where machine oil can accumulate. Discard this dough
when nished.
.
Use a dry pastry brush to remove any our or bits of dough from the hard to reach
places.
.
Lightly sprinkle some our on the Cutters. Using a dry brush, work the our into
the edges of the Pasta Machine Attachment. Brush all the our away and wipe the
machine clean again with a clean, dry cloth.
.
NEVER INSERT KNIVES BETWEEN THE CUTTERS!
CLEANING
ASSEMBLY
1. To attach the Pasta
Machine to the table or
countertop position the
Pasta Machine near the
edge of the work surface.
2. Silde the C-Clamp into
the C-Clamp Hole in the
side of the Pasta Machine
.
3. Tighten the screw on
the C-Clamp to secure the
Pasta Machine to the table
or countertop.
4. Slide the Cutter
Attachment onto the
attachment clip of the
Pasta Machine.
5. Slide the Handle into the Drive Hole of the Roller or the Attachment to be used.
Be sure to notice when the Handle turns, it passes below the edge of the work surface
and turns freely.
Specic instructions on the use of each Pasta Machine Attachment is included in
the Pasta Machine Instruction Book.
For questions or further instructions, contact
Weston Products at 1-800-814-4895.
Attachment Clips
Attachment Clips
Pasta Machine Attachment
Roller Drive
Hole
Handle
C-Clamp Hole
C-Clamp
Pasta Machine
Attachment Drive Hole
FOR WARRANTY INFORMATION, Log onto
www.WestonProducts.com -Customer Care