BEG-S BEG-M NEED HELP? CANTO Have product questions? Need technical support? pro Please feel free to contact. a
Please read this manual carefully before using this product.
3.Door Installation: For model BEG-S ard refer to Fig.3 below: There will be two separately packaged doors need to be assembled, take one of them and make sure the upper and lower door bolt can be slid into the corresponding sockets at the same time, Note: Please make sure the door handle on the top should be facing the outside of food warmer, 4. Shelf Installation: For Model BEG-S and BEG-M, the adjustable shaves have been assembled In advance for your convenience.
2 You can tum on the light switch when in the dark. The light color will change with the "ON-OFF-ON" cycle, 3 colors in all, 3, If humidity is required, add water to the water pan, You should check regularly during operation, 4 To turn off the unit, set the thermostat to the lowest setting and tum off the light. 5. Unplug the unit when not in use. 6, If using the water pan, cool the water completely before removing and treating the water, 7.
Thermostat off Tum on the thermostat Defective Thermostat, | CO act the purchase ie or Heating Element Tonics agent Monotheistic | Insufficient preheating | "redneck 30 minutes to enough reach operating temperature Temperature setting is | Change the temperature too low to a higher setting Door(s) are not closed | Make sure door(s) are completely ‘completely closed Temperature setting is | Change the temperature too high to a lower setting Unit is connected to Contact authorized Unitas too hot | incorrect p
